set pinhole name name external-port-end [ 0 - 49151 ]

Specifies the last port number in the range being translated.

set pinhole name name internal-ip internal-ip

Specifies the IP address of the internal host to which traffic of the specified type should be transferred.

set pinhole name name internal-port [ 0 - 65535 ]

Specifies the port number your Netopia Gateway should use when forwarding traffic of the specified type. Under most circumstances, you would use the same number for the exter- nal and internal port.

PPPoE /PPPoA Settings

You can use the following commands to configure basic settings, port authentication set- tings, and peer authentication settings for PPP interfaces on your Netopia Gateway.

Configuring Basic PPP Settings.

NOTE:

For the DSL platform you must identify the virtual PPP interface [vccn], a num- ber from 1 to 8.

set ppp module [vccn] option { on off }

Enables or disables PPP on the Netopia Gateway.

set ppp module [vccn] auto-connect { on off }

Supports manual mode required for some vendors. The default on is not normally changed. If auto-connect is disabled (off), you must manually start/stop a ppp connection.

264

Page 264
Image 264
Netopia 2200 manual PPPoE /PPPoA Settings