Netopia 2200 manual Set security state-insp udp-timeout 30, 277

CONFIG Commands

set security state-insp udp-timeout [ 30 - 65535 ]

Sets the stateful inspection UDP timeout interval, in seconds.

set security state-insp xposed-addr exposed-address# "n"

Allows you to add an entry to the specified list, or, if the list does not exist, creates the list for the stateful inspection feature. xposed-addrsettings only apply if NAT is off.

Example:

set security state-insp xposed-addr exposed-address# (?): 32

32 has been added to the xposed-addrlist.

Sets the exposed list address number.

set security state-insp xposed-addr exposed-address# "n" start-ip ip_address

Sets the exposed list range starting IP address, in dotted quad format.

set security state-insp xposed-addr exposed-address# "n" end-ip ip_address

Sets the exposed list range ending IP address, in dotted quad format.

32 exposed addresses can be created. The range for exposed address numbers are from 1 through 32.

set security state-insp xposed-addr exposed-address# "n" protocol [ tcp udp both any ]

Sets the protocol for the stateful inspection feature for the exposed address list. Accepted values for protocol are tcp, udp, both, or any.

If protocol is not any, you can set port ranges:

277