CONFIG Commands
This section describes the keywords and arguments for the various CONFIG commands.
DSL Commands
ATM Settings. You can use the CLI to set up each ATM virtual circuit.
set atm option {on off }
Enables the WAN interface of the Netopia Gateway to be configured using the Asynchro- nous Transfer Mode (ATM) protocol.
set atm [vcc n] option {on off }
Selects the virtual circuit for which further parameters are set. Up to eight VCCs are sup- ported; the maximum number is dependent on your Netopia Operating System tier and the capabilities that your Service Provider offers.
set atm [vcc n] qos service-class { cbr ubr vbr }
Sets the Quality of Service class for the specified virtual circuit – Constant (cbr), Unspeci- fied (ubr), or Variable (vbr) Bit Rate.
•ubr: No configuration is needed for UBR VCs. Leave the default value 0 (maximum line rate).
•cbr: One parameter is required for CBR VCs. Enter the Peak Cell Rate that applies to the VC. This value should be between 1 and the line rate. You set this value according to specifications defined by your service provider.
•vbr: Three parameters are required for VBR VCs. Enter the Peak Cell Rate, the Sus- tained Cell Rate, and the Maximum Burst Size that apply to the VC. You set these values according to specifications defined by your service provider.
set atm [vcc n] qos peak-cell-rate { 1 ...n }
If QoS class is set to cbr or vbr then specify the
that should apply to the line rate.
The Peak Cell Rate (PCR) should be set to the maximum rate a PVC can oversubscribe its Sustained Cell Rate (SCR). The Peak Cell Rate (see below) must be less than, or equal to
