CONFIG Commands
set ip ip-ppp [vccn] address ip_address
Assigns an IP address to the virtual PPP interface. If you specify an IP address other than 0.0.0.0, your Netopia Gateway will not negotiate its IP address with the remote peer. If the remote peer does not accept the IP address specified in the ip_address argument as valid, the link will not come up.
The default value for the ip_address argument is 0.0.0.0, which indicates that the vir- tual PPP interface will use the IP address assigned to it by the remote peer. Note that the remote peer must be configured to supply an IP address to your Netopia Gateway if you enter 0.0.0.0 for the ip_address argument.
set ip ip-ppp [vccn] peer-address ip_address
Specifies the IP address of the peer on the other end of the PPP link. If you specify an IP address other than 0.0.0.0, your Netopia Gateway will not negotiate the remote peer's IP address. If the remote peer does not accept the address in the ip_address argument as its IP address (typically because it has been configured with another IP address), the link will not come up.
The default value for the ip_address argument is 0.0.0.0, which indicates that the vir- tual PPP interface will accept the IP address returned by the remote peer. If you enter 0.0.0.0, the peer system must be configured to supply this address.
set ip ip-ppp [vccn] restriction { admin-disabled none }
Specifies restrictions on the types of traffic the Netopia Gateway accepts over the PPP vir- tual circuit. The
set ip ip-ppp [vccn] addr-mapping { on off }
Specifies whether you want the Netopia Gateway to use network address translation (NAT) when communicating with remote routers. Network address translation lets you conceal details of your network from remote routers. By default, address mapping is turned on.
