Netopia 2200 Set snmp notify type v1-trap v2-trap inform, System Settings, Set system name name

CONFIG Commands

SNMP Notify Type Settings

SNMP Notify Type is supported beginning with Firmware Version 7.4.2.

set snmp notify type [ v1-trap v2-trap inform ]

Sets the type of SNMP notifications that the system will generate:

•v1-trap– This selection will generate notifications containing an SNMPv1 Trap Protocol Data Unit (PDU)

•v2-trap– This selection will generate notifications containing an SNMPv2 Trap PDU

•inform – This selection will generate notifications containing an SNMPv2 InformRe- quest PDU.

System Settings

You can configure system settings to assign a name to your Netopia Gateway and to spec- ify what types of messages you want the diagnostic log to record.

set system name name

Specifies the name of your Netopia Gateway. Each Netopia Gateway is assigned a name as part of its factory initialization. The default name for a Netopia Gateway consists of the word “Netopia-3000/XXX” where “XXX” is the serial number of the device; for example, Netopia-3000/9437188. A system name can be 1 – 255 characters long. Once you have assigned a name to your Netopia Gateway, you can enter that name in the Address text field of your browser to open a connection to your Netopia Gateway.

☛NOTE:

Some broadband cable-oriented Service Providers use the System Name as an important identification and support parameter. If your Gateway is part of this type of network, do NOT alter the System Name unless specifically instructed by your Service Provider.

283