Netopia 2200 Set ppp module vccn port-authentication username username, Ethernet Port Settings

CONFIG Commands

CHAP and specify the same name and secret on the Netopia Gateway before the link can be established.

set ppp module [vccn] port-authentication option [ off on pap-only chap-only ]

Specifying on turns both PAP and CHAP on, or you can select PAP or CHAP. Specify the username and password when port authentication is turned on (both CHAP and PAP, CHAP or PAP.) Authentication must be enabled before you can enter other information.

set ppp module [vccn] port-authentication username username

The username argument is 1 – 255 alphanumeric characters. The information you enter must match the username configured in the PPP peer's authentication database.

set ppp module [vccn] port-authentication password password

The password argument is 1 – 128 alphanumeric characters. The information you enter must match the password used by the PPP peer.

Ethernet Port Settings

set ethernet ethernet A mode { auto 100M-full 100M-full-fixed 100M-half-fixed 10M-full-fixed 10M-half-fixed 100M-half 10M-full 10M-half }

Allows mode setting for the ethernet port. Only supported on units without a LAN switch, or dual ethernet products (338x). In the dual ethernet case, “ethernet B” would be specified for the WAN port. The default is auto.

Command Line Interface Preference Settings

You can set command line interface preferences to customize your environment.

set preference verbose { on off }

Specifies whether you want command help and prompting information displayed. By default, the command line interface verbose preference is turned off. If you turn it on, the command line interface displays help for a node when you navigate to that node.

267