Netopia 2200 manual Set ip prioritize off on, Set diffserv option off on, 258

IP Prioritization

set ip prioritize [ off on ]

Allows you to support traffic that has the TOS bit set. This defaults to off.

Differentiated Services (DiffServ)

The commands in this section are supported beginning with Firmware Version 7.4.2.

set diffserv option [ off on ]

Turns the DiffServ option off (default) or on. on enables the service and IP TOS bits are used, even if no flows are defined. Consequently, if the end-point nodes provide TOS set- tings from an application that can be interpreted as one of the supported states, the Gate- way will handle it as if it actively marked the TOS field itself.

☛NOTE:

The Gateway itself will not override TOS bit settings made by the endpoints. Support for source-provided IP TOS priorities within the Gateway is achieved simply by turning the DiffServe option “on” and by setting the lohi-asymmetry to adjust the behavior of the Gateway’s internal queues.

set diffserv lohi-ratio [ 60 - 100 percent ]

Sets a percentage between 60 and 100 used to regulate the level of packets allowed to be pending in the low priority queue. The default is 92. It can be used in some degree to adjust the relative throughput bandwidth for low- versus high-priority traffic.

258