Netopia 2200 manual WAN Commands

WAN Commands

atmping vccn [ segment end-to-end ]

Lets you check the ATM connection reachability and network connectivity. This command sends five Operations, Administration, and Maintenance (OAM) loopback calls to the speci- fied vpi/vci destination. There is a five second total timeout interval.

Use the segment argument to ping a neighbor switch.

Use the end-to-endargument to ping a remote end node.

reset dhcp client release [ vcc-id]

Releases the DHCP lease the Netopia Gateway is currently using to acquire the IP settings for the specified DSL port. The vcc-ididentifier is an “index” letter in the range B-I, and does not directly map to the VCC in use. Enter the reset dhcp client release command without the variable to see the letter assigned to each virtual circuit.

reset dhcp client renew [ vcc-id]

Releases the DHCP lease the Netopia Gateway is currently using to acquire the IP settings for the specified DSL port. The vcc-ididentifier is an “index” letter in the range B-I, and does not directly map to the VCC in use. Enter the reset dhcp client release without the variable to see the letter assigned to each virtual circuit.

reset dsl

Resets any open DSL connection.

reset ppp vccn

Resets the point-to-point connection over the specified virtual circuit. This command only applies to virtual circuits that use PPP framing.

show atm [all]

Displays ATM statistics for the Netopia Gateway. The optional all argument displays a more detailed set of ATM statistics.

236