If you specify v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a maximum of 31 characters, and must match the other router(s) keys for proper operation of MD5 support.

set ip dsl vccn rip-receive

{ off v1 v2 v1-compat v2-MD5 }

Specifies whether the Netopia Gateway should use Routing Information Protocol (RIP) broadcasts to update its routing tables with information received from other routers.

If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings with a maximum of 31 characters, and must match the other router(s) keys for proper oper- ation of MD5 support.

Ethernet LAN Settings

set ip ethernet A option { on off }

Enables or disables communications through the designated Ethernet port in the Gateway. You must enable TCP/IP functions for an Ethernet port before you can configure its network settings.

set ip ethernet A address ip_address

Assigns an IP address to the Netopia Gateway on the local area network. The IP address you assign to the local Ethernet interface must be unique on your network. By default, the Netopia Gateway uses 192.168.1.254 as its LAN IP address.

set ip ethernet A broadcast broadcast_address

Specifies the broadcast address for the local Ethernet interface. IP hosts use the broad- cast address to send messages to every host on your network simultaneously.

The broadcast address for most networks is the network number followed by 255. For example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255.

252

Page 252
Image 252
Netopia 2200 manual Set ip dsl vccn rip-receive Off v1 v2 v1-compat v2-MD5, Set ip ethernet a option on off, 252