Carrier Access Fax-protocol, Syntax config-dpeer-fxs# fax-protocol nonepass-throught38, T38

Configuration - Dial Peer FXS Mode

fax-protocol

Use the Dial Peer fax-protocolcommand to configure the fax protocol.

Syntax: (config-dpeer-fxs)# fax-protocol {nonepass-throught38}

Field	Definition
none	A Fax call would be treated as a normal voice call. Default.
pass-through	Will cause the line to transmit in G.711 mode, with echo cancellation
	and silence suppression disabled, on detection of Fax tone.
t38	Upon detection of a Fax tone on the port, will cause the gateway to
	negotiate a T.38 session with its peer and if successful, will enter T.38
	Fax-relay mode. Will dynamically consume a T.38 token for the
	session.
	Note: For the MSR, T.38 will be supported in a future release.

Example: (config-dpeer-fxs)# fax-protocol none

Supported Platforms: Adit 3104, Adit 3500, MSR

history

Use the history command to display commands that have been entered in this session. This command can be entered in any configuration mode.

Syntax: (config-dpeer-fxs)# history

Example: (config-dpeer-fxs)# history

history block-out-caller-id enable call-wait-caller-id enable call-waiting enable calling-party-disc enable codec preference 1 g729 history

Supported Platforms: Adit 3104, Adit 3500, MSR

8-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI