Carrier Access none manual Ds0-group, Syntax config-cont-t1-n# ds0-group timeslots range

Configuration - T1 Controller Mode

ds0-group

Use the Controller T1 ds0-groupcommand to create a group of T1s. To delete a DS0 group, see no ds0-groupcommand on page 6-9.

Syntax: (config-cont-t1-{n})# ds0-group timeslots range

Field

range

Definition

DS0 timeslot range, in the format n-n(1-4). Range is 1 - 24.

Example: (config-cont-t1-1)# ds0-group timeslots 1-4

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file. This command can be entered in any configuration mode with the same result.

Syntax: (config-cont-t1-{n})# end

Example: (config-cont-t1-1)# end

#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-cont-t1-{n})# exit

Example: (config-cont-t1-1)# exit

(config)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

6-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI