Carrier Access none manual Syntax config-l2tpc-n# ip ospf hello-interval seconds

Configuration - L2TPC Mode

ip ospf disable

Use the L2TPC ip ospf disable command to disable OSPF processing on this interface. To enable OSPF on this interface, see no ip ospf disable command on page 15-15.

Syntax: (config-l2tpc-{n})# ip ospf disable all

Example: (config-l2tpc-1)# ip ospf disable all

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip ospf hello-interval

Use the L2TPC ip ospf hello-intervalcommand to define the interval of time between hello packets sent on the interface. To reset the interval of time to the default setting of the path cost to the default setting of 10 seconds, see no ip ospf hello-intervalcommand on page 15-15.

Syntax: (config-l2tpc-{n})# ip ospf hello-interval seconds

Field	Definition
seconds	Range is 1-65535 seconds, with a default of 10.
	Note: This value must be the same for all nodes on the network.

Example: (config-l2tpc-1)# ip ospf hello-interval 12

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip ospf message-digest-key

Use the L2TPC ip ospf message-digest-keycommand to enable OSPF MD5 (Message-Digest) authentication. To remove an old MD5 key, see no ip ospf message-digest-keycommand on page 15-16.

Syntax: (config-l2tpc-{n})# ip ospf message-digest-key key-idmd5 key

Field

key-id

key

Definition

Enter an ID for this key. Range is 1-255.

Enter a alphanumeric password, with up to 8 characters.

Example: (config-l2tpc-1)# ip ospf message-digest-key 1 md5 key1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

15-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI