Carrier Access none manual Remote-subnet, Syntax config-ipsec-n# schedule-availability rule-id

Configuration - IPSec Mode

remote-subnet

Use the IPSec remote-subnetcommand to set the remote subnet IP address.

Syntax: (config-ipsec-{n})# remote-subnet {nonerange {start-address address end-address address}single ip addresssubnet ip address}

Field	Definition
none	No IP address.
range	Enter an IP address range.
	start-address- Enter the start IP address of the range.
	end-address- Enter the end IP address of the range.
single ip	Enter a single IP address.
subnet ip	Enter a subnet IP address.

Syntax: (config-ipsec-1)# remote-subnet single ip 10.10.2.200 mask 255.255.0.0

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

schedule-availability

Use the IPSec schedule-availabilitycommand to apply a schedule rule to this connection. To reset to the default value of "always", see no schedule-availabilitycommand on page 14-15.

Syntax: (config-ipsec-{n})# schedule-availability rule-id

Field	Definition
rule-id	Enter an existing schedule

Example: (config-ipsec-1)# schedule-availability rule1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

14-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI