Carrier Access none manual Adit 3000 Rel .6 and MSR Card Rel 2.0 CLI

Configuration - L2TPC Mode

no ip default-route

Use the L2TPC no ip default-routecommand to disable the default route. To set the default IP address, see ip default-routecommand on page 15-5.

Syntax: (config-l2tpc-{n})# no ip default-route

Example: (config-l2tpc-1)# no ip default-route

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf authentication

Use the L2TPC no ip ospf authentication command to disable the authentication method for this serial interface. To enable the authentication type for this interface see ip ospf authentication command on page 15-6.

Syntax: (config-l2tpc-{n})# no ip ospf authentication

Example: (config-l2tpc-1)# no ip ospf authentication

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf authentication-key

Use the L2TPC no ip ospf authentication-keycommand to remove a password to be used by neighboring routers, that are using OSPF’s simple password authentication.To assign a password, see ip ospf authentication-keycommand on page 15-7.

Syntax: (config-l2tpc-{n})# no ip ospf authentication-key

Example: (config-l2tpc-1)# no ip ospf authentication-key

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf cost

Use the L2TPC no ip ospf cost command to reset the cost path to the default setting of 0. To define the cost of sending a packet on this serial interface, see ip ospf cost command on page 15-7.

Syntax: (config-l2tpc-{n})# no ip ospf cost

Example: (config-l2tpc-1)# no ip ospf cost

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

15-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI