Configuration - T1 Controller Mode

shutdown

Use the Controller T1 shutdown command to set the T1 interface down (out-of-service). To set the T1 up (in-service) see no shutdown command on page 6-10.

Syntax: (config-cont-t1-{n})# shutdown

Example: (config-cont-t1-1)# shutdown

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

tdm-group

Use the Controller T1 tdm-groupcommand to create a group and define its direction. To delete a TDM group, see no tdm-groupcommand on page 6-10.

Syntax: (config-cont-t1-{n})# tdm-group timeslots range dir {inin-outout}

Field

Definition

range

TDM timeslot range, in the format n-n(1-4). Range is 1 - 24.

 

 

in

Defines the direction as incoming only.

 

 

in-out

Defines the direction as both incoming and outgoing.

 

 

out

Defines the direction as outgoing only.

 

 

Example: (config-cont-t1-1)# tdm-group timeslots 1-4 dir in-out

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI

6-11

Page 209
Image 209
Carrier Access none manual Tdm-group, Example config-cont-t1-1# tdm-group timeslots 1-4 dir in-out