Carrier Access none Date summer-time, Example config# date summer-time 03 28 0000 10 28 0100

Global Configuration Mode

Global Configuration Commands

date summer-time

Use the date summer-timecommand to update the clock for daylight savings time. To stop the update for daylight saving, see no date summer-timecommand on page 4-38.

Note: Default settings are start: 3/28 time 00:00, end: 10/28 time 01:00.

Syntax: (config)# date summer-timesmonth sday shh:mm emonth eday ehh:mm offset

Field	Definition
smonth and emonth	The month in which daylight savings time starts (smonth) or ends
	(emonth). Range is 1-12.
sday and eday	The day on which daylight savings time starts (sday) or ends (eday).
	Range is 1-31.
shh:mm and ehh:mm	Start time (shh:mm) and end time (ehh:mm).
	hh = hour, range 00:59
	mm = minutes, range 00:59
offset	This is an optional parameter, to set the offset of the daylight savings
	time. Range is 1-120, with a default of 60.

Example: (config)# date summer-time 03 28 00:00 10 28 01:00 60

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Note: By default, Time of Day management for the MSR is provided by the Adit 600 controller. Use this command with the MSR only if you are using NTP or another time service and need to manually adjust the time due to a loss of contact with the server.

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-9