Carrier Access none manual Syntax config-dpeer-trk# end Example config-dpeer-trk# end

Configuration - Dial Peer Trunk Mode

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file.

Syntax: (config-dpeer-trk)# end

Example: (config-dpeer-trk)# end

#

Supported Platforms: Adit 3500, MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-dpeer-trk)# exit

Example: (config-dpeer-trk)# exit

(config)#

Supported Platforms: Adit 3500, MSR

fax-protocol

Use the Dial Peer fax-protocolcommand to configure the fax protocol.

Syntax: (config-dpeer-trk)# fax-protocol {nonepass-throught38}

Field	Definition
none	A Fax call would be treated as a normal voice call. Default.
pass-through	Will cause the line to transmit in G.711 mode, with echo cancellation
	and silence suppression disabled, on detection of Fax tone.
t38	Upon detection of a Fax tone on the port, will cause the gateway to
	negotiate a T.38 session with its peer and if successful, will enter T.38
	Fax-relay mode. Will dynamically consume a T.38 token for the
	session.
	Note: For the MSR, T.38 will be supported in a future release.

Example: (config-dpeer-trk)# fax-protocol none

Supported Platforms: Adit 3500, MSR

9-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI