Carrier Access none manual Ip address, Auto, Secondary

Configuration - Ethernet Interface Mode

history

Use the history command to display commands that have been entered in this session. This command can be entered in any configuration mode.

Syntax: (config-int-eth-{n})# history

Example: (config-int-eth-1)# history

schedule-availability rule1 history

full-duplex ip rip

ip rip enable ip address speed auto history

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip address

Use the Ethernet Interface ip address command to set the IP address for the Ethernet port. To remove an IP address, see no ip address command on page 11-17.

Syntax: (config-int-eth-{n})# ip address {address mask mask [secondary] auto}

Field	Definition
address	Enter an IP address to assign to the Ethernet port.
mask	Enter a subnet mask for the Ethernet IP address.
auto	Use DHCP to assign an IP address.
secondary	This optional parameter, defines the address to be a secondary IP
	address.

Example: (config-int-eth-1)# ip address 192.168.2.100 mask 255.255.255.0

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

11-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI