Carrier Access none manual Syntax config-pptpc-n# no ip ospf message-digest-key key-id

Configuration - PPTPC Mode

no ip ospf hello-interval

Use the PPTP Client no ip ospf hello-intervalcommand to reset the interval of time to the default setting of the path cost to the default setting of 10 seconds. To define the interval of time between hello packets sent on the interface, see ip ospf hello-intervalcommand on page 17-8.

Syntax: (config-pptpc-{n})# no ip ospf hello-interval

Example: (config-pptpc-1)# no ip ospf hello-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf message-digest-key

Use the PPTP Client no ip ospf message-digest-keycommand to remove an old MD5 key. To enable OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-keycommand on page 17-8.

Syntax: (config-pptpc-{n})# no ip ospf message-digest-key key-id

Field

key-id

Definition

Enter an ID for this key. Range is 1-255.

Example: (config-pptpc-1)# no ip ospf message-digest-key 1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf priority

Use the PPTP Client no ip ospf priority command to set the router priority to the default setting of priority 1. To set the router priority, which determines the designated router for this network, see ip ospf priority command on page 17-9.

Syntax: (config-pptpc-{n})# no ip ospf priority

Example: (config-pptpc-1)# no ip ospf priority

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 17-15