Carrier Access none manual No area authentication, No area stub

Configuration - OSPF Mode

no commands

no area

Use the Router OSPF no area command to remove a specific area from the OSPF configuration. To set an area, see the area commands command on page 16-2,or area stub command on page 16-2,the first use of either command will set the area.

Syntax: (config-ospf)# no area area-id

Field	Definition
area-id	ID of area to be removed, in the form:
	area number - Range 0-4294967295
	area IP address - IP address of the area.

Example: (config-ospf)# no area 1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no area authentication

Use the Router OSPF no area authentication command to remove an area’s authentication. See the area commands command on page 16-2for the counterpart of this command.

Syntax: (config-ospf)# no area area-idauthentication

Field	Definition
area-id	Area ID for which authentication is to be removed, in the form:
	area number - Range 0-4294967295
	area IP address - IP address of the area.

Example: (config-ospf)# no area 1 authentication

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no area stub

Use the Router OSPF no area stub command to remove the definition of an area as a Stub area. See the area stub command on page 16-2for the counterpart of this command.

Syntax: (config-ospf)# no area area-idstub

Field	Definition
area-id	Identifier of the stub area, in the form:
	ID number - Range 0-4294967295
	IP address - IP address of the area.

Example: (config-ospf)# no area 1 stub

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 16-7