Carrier Access none Snmp-server host, Snmp-server traps enable, Snmp-server trusted-ip, Version

Global Configuration Mode

Global Configuration Commands

snmp-server host

Use the snmp-server host command to set a SNMP host.

Syntax: (config)# snmp-server host address {community

community-nameversion {12c}

Field	Definition
address	Enter an destination IP address.
community-name	Enter the SNMP community name.
version	1 - SNMPv1
	2c - SNMPv2c

Example: (config)# snmp-server host 192.168.1.1 version 1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

snmp-server traps enable

Use the snmp-server traps enable command to enable SNMP traps on the system. To delete a SNMP server trap, see no snmp-server traps command on page 4-50.

Syntax: (config)# snmp-server traps enable

Example: (config)# snmp-server traps enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

snmp-server trusted-ip

Use the snmp-servertrusted-ipcommand to set a SNMP trusted peer (The IP address, or subnet address that identifies which remote management stations are allowed to perform SNMP operations).

Syntax: (config)# snmp-server trusted-ip {addressany} [trusted-mask mask]

Field	Definition
address	Enter an IP address of a trusted peer.
any	Allow any IP address trusted peer access.
trusted-mask mask	This is an optional parameter, enter the subnet mask of the trusted peer
	IP address.

Example: (config)# snmp-server trusted ip any

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-61