Carrier Access none manual Registration enable, Registration line authentication

Configuration - Voice Port Trunk Mode

registration

The registration command enables the user to Add, Edit, Remove, Enable, Disable PBX line number behind a voice trunk that will register to the SIP proxy.

registration enable

Use the Voice Port Trunk registration enable command to enable the Voice Port registration feature. To disable Voice Port registration, see no registration enable command on page 24-9.

Syntax: (config-vport-trk-{n})# registration enable

Example: (config-vport-trk-1)# registration enable

Supported Platforms: Adit 3500, MSR

registration line authentication

Use the Voice Port Trunk registration line authentication command to configure the username to authenticate.

Syntax: (config-vport-trk-{n})# registration line value line-numbers value authentication {phone-numberusername username} password password

Field	Definition
line value	Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value	Define the number of lines in this block that are going to be registered.
	Starting from the first-phone-number, increased by 1 each.
phone-number	Set the phone number to authenticate.
username username	Set the user name to authenticate.
password	Enter a password for the authentication.

Example: (config-vport-trk-1)# registration line 1 line-numbers 3 authentication phone-number password hello

Supported Platforms: Adit 3500, MSR

24-12 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI