Carrier Access none manual Show ipsec, Syntax # show ipsec vpnipsecconnection-id

Privileged Mode

show ipsec

Use the show ipsec command to display the IPSec Connections or the connection configuration information.

Syntax: # show ipsec [vpn_ipsecconnection-id]

Field	Definition
connection-id	Enter the name of a connection.

Example: adit 3500# show ipsec vpn_ipsec 0 vpn_ipsec 1 vpn_ipsec 2 vpn_ipsec 3

Example: adit 3500# show ipsec vpn_ipsec2

Device = test State = Enabled tatus = No VPN software license Schedule Availability = Always

Remote Tunnel Endpoint Address = 192.168.1.200 Security Association Mode = Tunnel

Remote Subnet = None

Route NetBOIS Broadcasts = Enabled Dead Period Detection = Disable

Remote Broadcast Address = 192.168.1.200 Key Exchange Method = Automatic Auto_Reconnect = Enabled

Mode = Main Mode Negotiation Attempts = 3 Rekey Life Time = 3600 sec Rekey Margin = 540

Rekey Fuzz Percent = 100

Peer Authentication = Shared Secret Shared Secret = mysecret

Encryption = 3des, Hash = md5,sha1, Group = grp2,grp5,

Lifetime = 28000 sec

Use PFS = Enabled

Group = Same group as phase 1

AH Transform = md5,sha1,

ESP Encryption Transform = esp-3des,

ESP Authentication Transform = esp-md5,esp-sha1,

IP Compression = Disabled

Default Route = Disabled

RIP = Enabled

RIP Listen Msg. = RIPv1/2

RIP Send Msg. = None

OSPF = Disabled

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

3-46 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI