Privileged Mode

show ip ospf interface

Use the show ip ospf interface command to display OSPF related interface information.

Syntax: # show ip ospf interface {ethernet portserial portmultilink

port}

Field

Definition

ethernet port

Display information on the Ethernet interface.

 

port = 1 or 2

 

 

serial port

Display information on the serial interface.

 

Adit 3104: Value must be 1.

 

Adit 3500: Range = 1-4.

 

MSR: Range = 1-8.

 

 

multilink port

Display information on the Multilink interface.

 

Adit 3104, Adit 3500, MSR: Value must be 1

 

 

Example: adit 3500# show ip ospf interface ethernet 1

Ethernet 1 is up, line protocol is up

Internet Address 192.168.254.202, Mask 255.255.255.0, Area 0.0.0.0

AS 201, Router ID 192.168.99.1, Network Type BROADCAST, Cost: 10

Transmit Delay is 1 sec, State OTHER, Priority 1

Designated Router id 192.168.254.10, Interface address 192.168.254.10 Backup Designated router id 192.168.254.28, Interface addr 192.168.254.28 Timer intervals configured, Hello 10, Dead 60, Wait 40, Retransmit 5 Hello due in 0:00:05

Neighbor Count is 8, Adjacent neighbor count is 2

Adjacent with neighbor 192.168.254.28 (Backup Designated Router)

Adjacent with neighbor 192.168.254.10 (Designated Router)

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

3-44

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI

Page 102
Image 102
Carrier Access none manual Show ip ospf interface, Example adit 3500# show ip ospf interface ethernet