Carrier Access none manual Ip dhcp pool ethernet, Ip domain-name, Ip host

Global Configuration Mode

Global Configuration Commands

ip dhcp pool ethernet

Use the ip dhcp pool ethernet command to allow access to the DHCP configuration commands. See Chapter 7, Configuration - DHCP Pool Ethernet Mode for commands in this mode. For the no counterpart, see no ip dhcp pool ethernet command on page 4-43.

Syntax: (config)# ip dhcp pool ethernet port

Field

port

Definition

Selects the Ethernet port to configure. Range is 1-2.

Example: (config)# ip dhcp pool ethernet 1 (config-dhcp-eth-1)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip domain-name

Use the ip domain-namecommand to sets system domain name.

Syntax: (config)# ip domain-name name

Field

name

Definition

Enter the domain name of the device.

Example: (config)# ip domain-name mydomain.com

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip host

Use the ip host command to set the host name for this device.

Syntax: (config)# ip host hostname

Field	Definition
hostname	Enter the name of the host. Default is adit3500, adit3104, or aditMSR
	(depending on the platform).

Example: (config)# ip host gateway1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-25