Carrier Access none manual Access-control, Lan Wan, Always

Global Configuration Mode

Global Configuration Commands

access

Use the access command to enable remote access via LAN or WAN. To disable remote access, see no access command on page 4-36.

Syntax: (config)# access {lanwan} enable

Field

lan

wan

Definition

Enable remote access via the LAN.

Enable remote access via the WAN.

Example: (config)# access lan enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

access-control

Use the access-controlcommand to configure an access (scheduler) rule for the system. To remove a rule, see no access-controlcommand on page 4-36.

Syntax: (config)# access-control name apply-to {lanobject-name} time-range {alwaysschedule-id} service service-id

Field	Definition
name	Enter a name for the Access Control (Scheduler Rule), with a
	maximum of 64 characters.
lan	Apply this scheduler rule to the LAN interface.
object-name	Enter the Network Object name to apply the rule to.
always	Apply this rule always. Default.
schedule-id	A configured schedule to apply this rule.
service-id	Enter the service number to apply the rule to.
	Note: The Service ID number can be found with the show service
	command, on page 3-61

Example: (config)# access-control AccessControl_1 apply-to lan time-range always service 16777220

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

4-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI