Carrier Access none No ip ospf authentication-key, No ip ospf cost, No ip ospf dead-interval

Configuration - Ethernet Interface Mode

no ip ospf authentication

Use the Ethernet Interface no ip ospf authentication command to disable the authentication method for this Ethernet interface. To enable the authentication type for this interface see ip ospf authentication command on page 11-9.

Syntax: (config-int-eth-{n})# no ip ospf authentication

Example: (config-int-eth-{n})# no ip ospf authentication

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf authentication-key

Use the Ethernet Interface no ip ospf authentication-keycommand to remove a password to be used by neighboring routers, that are using OSPF’s simple password authentication.To assign a password, see ip ospf authentication-keycommand on page 11-10.

Syntax: (config-int-eth-{n})# no ip ospf authentication

Example: (config-int-eth-1)# no ip ospf authentication-key

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf cost

Use the Ethernet Interface no ip ospf cost command to reset the cost path to the default setting of

0.To define the cost of sending a packet on this Ethernet interface, see ip ospf cost command on page 11-10.

Syntax: (config-int-eth-{n})# no ip ospf cost

Example: (config-int-eth-1)# no ip ospf cost

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf dead-interval

Use the Ethernet Interface no ip ospf dead-intervalcommand to reset the interval of time to the default setting of 40 seconds. To define the interval of time that no hello packets have been seen before neighbors declare the router down, see ip ospf dead-intervalcommand on page 11-10.

Syntax: (config-int-eth-{n})# no ip ospf dead-interval

Example: (config-int-eth-1)# no ip ospf dead-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

11-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI