Carrier Access none manual End, Syntax config-l2tpc-n# end Example config-l2tpc-1# end

Configuration - L2TPC Mode

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file. This command can be entered in any configuration mode with the same result.

Syntax: (config-l2tpc-{n})# end

Example: (config-l2tpc-1)# end

#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-l2tpc-{n})# exit

Example: (config-l2tpc-1)# exit

(config)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

firewall

Use the L2TPC firewall command to enable the configured firewall. To delete a preference, see no firewall command on page 15-13.

Syntax: (config-l2tpc-{n})# firewall enable

Example: (config-l2tpc-1)# firewall enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-3