Carrier Access none manual Local-server, New

Global Configuration Mode

Global Configuration Commands

local-server

Use the local-servercommand to configure the local server entries. To delete a local server, see the no local-servercommand on page 4-44.

Syntax: (config)# local-server id {namenew} {ip-address address hostname hostname} time-range {alwaysschedule-name} fwd-port port service service-id

Field	Definition
name	Enter a name of the server.
new	Select New to create a new local server.
address	Enter an IP address of the local server.
hostname	Enter a host name of the server.
always	Set the time range to
schedule-name	Enter a defined schedule to be applied to the server.
port	Enter a forwarding port.
service-id	Enter the service number to apply the rule to. Note: The Service ID
	number is displayed with the show service command, on page 3-61

Example: (config)# local-server id Boulder-server ip-address 10.10.2.100 time-range always fwd-port 2 service 16777220

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-27