Carrier Access none manual Syntax config-int-ser-n# no ip route dest-ip-addr gateway

Configuration - Serial Interface Mode

no ip primary-dns

Use the Serial Interface no primary-dnscommand to disable the primary DNS. To set the DNS primary IP address, see ip primary-dnscommand on page 13-11.

Syntax: (config-int-ser-{n})# no ip primary-dns

Example: (config-int-ser-1)# no ip primary-dns

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip rip

Use the Serial Interface no ip rip command to disable RIP on this interface. To enable RIP, see ip rip command on page 13-11.

Syntax: (config-int-ser-{n})# no ip rip

Example: (config-int-ser-1)# no ip rip

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip route

Use the Serial Interface no ip route command remove an IP route. To add a route, see ip route command on page 13-12.

Syntax: (config-int-ser-{n})# no ip route dest-ip-addr gateway

Field	Definition
dest-ip-addr	Enter destination IP address to remove.
gateway	Enter gateway IP address to remove.

Example: (config-int-ser-1)# no ip route 192.168.100.200 192.168.100.254

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip secondary-dns

Use the Serial Interface no secondary-dnscommand to disable the secondary DNS. To enable the secondary DNS, see ip secondary-dnscommand on page 13-13.

Syntax: (config-int-ser-{n})# no ip secondary-dns

Example: (config-int-ser-1)# no ip secondary-dns

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

13-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI