Carrier Access none manual Fax-protocol-t38 signaling, Feature-mode

Configuration - Voice Service SIP Mode

fax-protocol-t38 signaling

Use the Voice Service SIP fax-protocol-t38 signaling command to configure fax signaling. Note: For the MSR, T.38 will be supported in a future release.

Syntax: (config-voice-serv-sip)# fax-protocol-t38 signaling {nse-onlynse-preferredsdp-onlysdp-preferred}

Example: (config-voice-serv-sip)# fax-protocol-t38 signaling sdp-preferred

Syntax Descriptions:

Variable	Definition
nse-only	Named Service Element (NSE) will be the only method tried without any
	attempt to try alternate signaling method to establish connection if it fails.
sdp-only	Session Description Protocol (SDP) will be the only method tried without any
	attempt to try alternate signaling method to establish connection if it fails.
nse-preferred	Named Service Element (NSE) preferred will be the first method tried with an
	attempt to try the alternate SDP signaling method to connect if it fails.
sdp-preferred	Session Description Protocol (SDP) preferred will be the first method tried
	with an attempt to try the alternate NSE signaling method to connect if it fails.
	Default.

Supported Platforms: Adit 3104, Adit 3500, MSR

feature-mode

Use the Voice Service SIP feature-modecommand to determine where the intelligence for the calling features will lie, offering a choice between server-based (Info) and device-based (local) features.

Syntax: (config-voice-serv-sip)# feature-mode {infolocal}

Field

info

local

Definition

This selection is used with BroadSoft 11.1 Info Mode Proxy. Note: On a BroadSoft server, the Adit device must be configured as “Generic SIP Standard (Proxy Address)”.

Default is Local.

Example: (config-voice-serv-sip)# feature-mode info

Supported Platforms: Adit 3104, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 25-7