Carrier Access none manual End, Syntax config-dpeer-voip end Example config-dpeer-voip# end

Configuration - Dial Peer VoIP Mode

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file.

Syntax: (config-dpeer-voip) end

Example: (config-dpeer-voip)# end

#

Supported Platforms: Adit 3104, Adit 3500, MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-dpeer-voip)# exit

Example: (config-dpeer-voip)# exit

(config)#

Supported Platforms: Adit 3104, Adit 3500, MSR

history

Use the history command to display commands that have been entered in this session.

Syntax: (config-dpeer-voip)# history

Example: (config-dpeer-voip)# history

exit destination-pattern ddddd destination-pattern modem-protocol none sip-authentication sip-authentication enable history

Supported Platforms: Adit 3104, Adit 3500, MSR

10-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI