Carrier Access none manual Syntax config-cont-lcc-n# end Example config-cont-lcc-1# end

Configuration - LCC Controller Mode

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file. This command can be entered in any configuration mode with the same result.

Syntax: (config-cont-lcc-{n})# end

Example: (config-cont-lcc-1)# end

#

Supported Platforms: MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-cont-lcc-{n})# exit

Example: (config-cont-lcc-1)# exit

(config)#

Supported Platforms: MSR

5-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI