Carrier Access none manual Syntax config-int-mlink-n# ip ospf priority priority

Configuration - Multilink Interface Mode

ip ospf priority

Use the Multilink Interface ip ospf priority command to set the router priority, which determines the designated router for this network. To restore the default setting of priority 1, see no ip ospf priority command on page 12-16.

Syntax: (config-int-mlink-{n})# ip ospf priority priority

Field	Definition
priority	Enter an ID for this key. Range is 0-255.

Example: (config-int-mlink-1)# ip ospf priority 2

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip ospf retransmit-interval

Use the Multilink Interface ip ospf retransmit-intervalcommand to define the interval of time between link state advertisement retransmissions for adjacencies belonging to the interface. To restore the default value of 5 seconds, see no ip ospf retransmit-intervalcommand on page 12-17.

Syntax: (config-int-mlink-{n})# ip ospf retransmit-interval seconds

Field	Definition
seconds	Range is 1-65535 seconds, with a default of 5.

Example: (config-int-mlink-1)# ip ospf retransmit-interval 10

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip ospf transmit-delay

Use the Multilink Interface ip ospf transmit-delaycommand to define the estimated time to transmit a link state update packet on the interface. To restore the default value of 1 second, see no ip ospf transmit- delay command on page 12-17.

Syntax: (config-int-mlink-{n})# ip ospf transmit-delay seconds

Field	Definition
seconds	Range is 1-65535 seconds, with a default of 1.

Example: (config-int-mlink-1)# ip ospf retransmit-interval 10

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

12-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI