Pelco dx8100 manual Configuring Display Override, Appending an Existing Sequence List

7. Click Apply at the bottom of the External Monitor page.

3a

3b 3c ￿

Figure 179. Delete a Mapping Sequence

Appending an Existing Sequence List

To append an existing sequence list to the current list:

1.On the DX8100 toolbar, click . The Setup dialog box opens to the Camera page.

2.Click . The External Output page is displayed.

3.Click Load. The “Load profile” dialog box opens.

4.Select a profile.

5.Click OK.

The “Append to list” dialog box opens.

6.Click Yes to add the new sequences to the existing list.

7.To add, delete, or modify sequence instances, follow the directions in the sections above.

8.Click Save.

9.Select an existing profile or enter a new profile name to save the sequence list.

10.Click OK.

11.Click Apply in the Sequence Table section.

12.Click Apply.

CONFIGURING DISPLAY OVERRIDE

The Capture Card can be configured to interrupt normal output when a motion or alarm event is detected. Each event instance causes live video from the sensing camera to be displayed for up to 60 seconds after event detection.

To set up event monitor override options:

1.On the DX8100 toolbar, click . The Setup dialog box opens to the Camera page.

2.Click .

C2630M-B (4/08) 215