164 C2630M-B (4/08)
To configure Port 1 to Port 4 properties:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port drop-down box, select the port number you want to configure.
3. In the device drop-down box, select a device.
ATM/POS devices can use COM1 and Port 1 to Port 4. The KBD300A and third-party dome devices use Port 1 to Port 4. Forinformation on
interfacing ATM/POS devices to the DX8100 using COM1, refer to Setting Up COM1 Port Properties on page163.
4. Configure the following port settings using the drop-down box.
• Interface mode
• Baud rate
•Parity
• Data bits
• Stop bits
5. Click Apply.
SETTING UP ATM/POS DEVICE PROPERTIES
The DX8100 allows you to connect up to 16 ATM/POS devices and provides two ATM/POS device modes:
•Single Mode: Use this option to interface up to four ATM/POS devices to the DX8100.
•Multi Mode: Use this option to connect up to 16 ATM/POS devices to the DX8100 over one serial connection.
Single Mode and Multi Mode can be combined and allows you to connect up to 16 ATM/POS total devices to the DX8100. For informat ion about
installing the ATM/POS equipment for each mode, refer to the DX8100 Installation manual (C2629M).
This section describes how to configure ATM/POS device properties and includes the following topics:
•Selecting the ATM/POS Device Mode and Communications Options
•Setting Up an ATM/POS Data Format
•Assigning a Data Format to an ATM/POS Device on page173
•Setting Up ATM/POS Exceptions on page174
•Verifying the ATM/POS Communication Connection on page179
•Recording ATM/POS Events on page180

Selecting the ATM/POS Device Mode and Communications Options

This section describes the complete process for configuring DX8100 ATM/POS device communication options. For additional information about
each phase of the configuration process, refer to the following topics:
•Setting Up an ATM/POS Data Format
•Assigning a Data Format to an ATM/POS Device on page173
•Setting Up ATM/POS Exceptions on page174
•Verifying the ATM/POS Communication Connection on page179
•Recording ATM/POS Events on page180
To select the device mode and set up the ATM/POS communications options:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. Do one of the following:
•Single Mode: In the Communication Port drop-down box, select a port (COM1 or Port 1 to Port4).
•Multi Mode: In the Communication Port drop-down box, select COM1.
If you select COM1, the Interface Mode option is unavailable and is set to RS-232C by default.
3. In the device drop-down box, select ATM/POS and configure the following port settings using the drop-down boxes provided.
• Interface mode (by default is set for RS232C for COM1)