Carrier Access none manual No prefix, No session-target

Configuration - Dial Peer VoIP Mode

no commands

no destination-pattern

Use the Dial Peer no destination-patterncommand to remove a destination pattern. To set the destination pattern, see destination-patterncommand on page 10-2.

Syntax: (config-dpeer-voip)# no destination-pattern

Example: (config-dpeer-voip)# no destination-pattern

Supported Platforms: Adit 3104, Adit 3500, MSR

no prefix

Use the Dial Peer no prefix command to remove the prefix of the phone number. To define a prefix, see prefix command on page 10-6.

Syntax: (config-dpeer-voip)# no prefix

Example: (config-dpeer-voip)# no prefix 1303

Supported Platforms: Adit 3104, Adit 3500, MSR

no session-target

Use the Dial Peer no session-targetcommand to remove session target. To configure a session target, see session-targetcommand on page 10-6.

Syntax: (config-dpeer-voip)# no session-target

Example: (config-dpeer-voip)# no session target

Supported Platforms: Adit 3104, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 10-5