Carrier Access none manual Option, Relay

Configuration - DHCP Pool Ethernet Mode

option

Use the option command to configure DHCP options per RFC 2132. To delete an option, see no option command on page 7-5.

Syntax: (config-dhcp-eth-{n})# option {66 {enablevalue

{addresshostname}67 {enablevalue filename}

Field	Definition
66	66	- Send the TFTP server name.
		address - Enter the IP address of the TFTP server.
		hostname - Enter the host name of the TFTP server.
67	67	- Send the Boot file name.
		filename - Enter the boot file name.
enable	To enable the DHCP option.

Example: (config-dhcp-eth-1)# option value 66 10.10.5.100

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

relay

Use the DHCP Pool relay command to configure DHCP relay. The DHCP relay is responsible for forwarding the requests and responses negotiating between the DHCP clients and the server. To delete DHCP relay, see no relay command on page 7-5.

Syntax: (config-dhcp-eth-{n})# relay address1 [address2] [address3] ...

Field	Definition
address	The DHCP relay IP address, in the form of xxx.xxx.xxx.xxx, where
	xxx is between 0-255
address1, address 2,	Optional address parameter, to enter additional DHCP relay IP
...	addresses, in the form of xxx.xxx.xxx.xxx, where xxx is between
	0-255

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

7-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI