Carrier Access none manual Date auto-time-update, Date set, Ntp, Tod

Global Configuration Mode

Global Configuration Commands

date

date auto-time-update

Use the date auto-time-updatecommand to automatically update the clock from the defined server. To stop the auto update, see no date auto-time-updatecommand on page 4-37.

Syntax: (config)# date auto-time-update protocol {ntptod} server

address1 [address2] [address3] [address4] update-everyhours

Field	Definition
ntp	Network Time Protocol protocol. Default for Adit 3000.
tod	Time of Day protocol.
address1, address2,	Enter the IP Address of the Time Server. Additional addresses may be
...	added for backup if the primary Time Server fails.
hours	Sets the amount of time between resets. Range 1-480 hours. Default is
	24 hours.

Example: (config)# date auto-time-update protocol ntp server 192.168.1.1 update-every 24

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Note: By default, Time of Day management for the MSR is provided by the Adit 600 controller.

date set

Use the date set command to manually set the internal clock.

Syntax: (config)# date set hh:mm:ss dd mm yyyy

Field	Definition
hh:mm:ss	Set the time in the 24 hour format hh:mm:ss
	hh = hours, range is 0 - 23
	mm = minutes, range is 0 - 59
	ss = seconds, range is 0 - 59
dd	dd = day, range is 1 - 31
mm	mm = month, range is 1 - 12
yyyy	Enter current year (example 2006). Range 1970 - 2037.

Example: (config)# date set 05:00:00 04 17 2006

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Note: By default, Time of Day management for the MSR is provided by the Adit 600 controller. Use this command with the MSR only if you are using NTP or another time service and need to manually adjust the time due to a loss of contact with the server.

4-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI