Carrier Access none Authentication login, Clock source, None, Example config# clock 1 source t1

Global Configuration Mode

Global Configuration Commands

Field	Definition (Continued)
frag	enable - Enable fragmentation.
	none - Do not allow fragmentation.
log	Enable or disables logging of packets matched by this rule.

Example: (config)# access-list rule new apply eth-lan direction in operation accept time-range always src-host any dst-host any service 16777220 frag none log none

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

authentication login

Use the authentication login command to use RADIUS for login authentication. To remove an authentication login, see no authentication login command on page 4-37.

Syntax: (config)# authentication login use-radius

Example: (config)# authentication login use-radius

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

clock source

Use the clock source command to define the primary and secondary clock source.

Syntax: (config)# clock {12} source {nonet1 port}

Field	Definition
12	Sets the interface to the following clock source.
	1	= Clock 1, primary clock source
	2	= Clock 2, secondary clock source
none	Sets the clock source to internal.
t1 port	Sets the clock source to a DS1. Range is 1-4.

Example: (config)# clock 1 source t1 2

Supported Platforms: Adit 3104, Adit 3200, Adit 3500

Not supported by the MSR card

4-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI