Carrier Access none manual Syntax config-int-mlink-n# no ip address address

Configuration - Multilink Interface Mode

no commands

no firewall

Use the Multilink Interface no firewall command to disable the configured firewall. To enable the firewall on this interface, see firewall command on page 12-4.

Syntax: (config-int-mlink-{n})# no firewall

Example: (config-int-mlink-1)# no firewall

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip address

Use the Multilink Interface no ip address command to remove the IP address assigned to the port. To set the Ethernet IP address, see ip address command on page 12-5

Syntax: (config-int-mlink-{n})# no ip address address

Field	Definition
address	Enter the IP address to remove.

Example: (config-int-mlink-1)# no ip address 192.168.1.100

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip default-route

Use the Multilink Interface no ip default-routecommand to disable the default route. To set the default IP address, see ip default-routecommand on page 12-6.

Syntax: (config-int-mlink-{n})# no ip default-route

Example: (config-int-mlink-1)# no ip default-route

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf authentication

Use the Multilink Interface no ip ospf authentication command to disable the authentication method for this Multilink interface. To enable the authentication type for this interface see ip ospf authentication command on page 12-7.

Syntax: (config-int-mlink-{n})# no ip ospf authentication

Example: (config-int-mlink-{n})# no ip ospf authentication

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

12-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI