Carrier Access none manual Unnumbered, Example config-int-mlink-1# ip address 192.168.2.100 mask

Configuration - Multilink Interface Mode

history

Use the history command to display commands that have been entered in this session. This command can be entered in any configuration mode.

Syntax: (config-int-mlink-{n})# history

Example: (config-int-mlink-1)# history

description testdesc firewall enable

ip rip enable

pppauthentication pap ppp encryption 128-bit history

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip address

Use the Multilink Interface ip address command to configure the MLPPP IP address. To remove an IP address, see no ip address command on page 12-14.

Syntax: (config-int-mlink-{n})# ip address {address mask maskautounnumbered} [secondary]

Field	Definition
address	Enter an IP address to assign to the port.
mask	Enter a subnet mask for the IP address.
auto	Uses IPCP to assign an IP address.
unnumbered	Set the Multilink IP address to unnumbered.
secondary	This optional parameter, defines the address to be a secondary IP
	address.

Example: (config-int-mlink-1)# ip address 192.168.2.100 mask 255.255.255.0

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-5