Carrier Access none manual Registration line enable, Registration line first-phone-number

Configuration - Voice Port Trunk Mode

registration line enable

Use the Voice Port Trunk registration line enable command to enable registration. To disable registration, see no registration line enable command on page 24-10.

Syntax: (config-vport-trk-{n})# registration line value line-numbers value enable

Field	Definition
line value	Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value	Define the number of lines in this block that are going to be registered.
	Starting from the first-phone-number, increased by 1 each.

Example: (config-vport-trk-1)# registration line 4 line-numbers 3 enable

Supported Platforms: Adit 3500, MSR

registration line first-phone-number

Use the Voice Port Trunk registration line first-phone-numbercommand to define the first number in a block that will be registered.

Syntax: (config-vport-trk-{n})# registration line value line-numbers value first-phone-number phone-numberdescription description

Field	Definition
line value	Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value	Define the number of lines in this block that is going to be registered.
	Starting from the first-phone-number, increased by 1 each.
phone-number	Enter the first number in a block that will be registered.
description	Enter a description with a maximum of 20 characters.

Example: (config-vport-trk-1)# registration line 1 line-numbers 3

first-phone-number 3032185555 description turin

Supported Platforms: Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 24-13