Chapter 2 Configuring The Validator

Requesting A Validator Report

This procedure prints a summarized validator report on the printer itself.

.

1. Press .. to take the printer offline and place the printer in Menu mode.

2. If necessary, press and at the same time to unlock the key.

.

3. If necessary, press .. until “VALIDATOR” displays.

4. Press until “Validator Report” displays.

5. Press to print the report.

6. Press and at the same time to lock the key, then press PAUSE to take the printer offline.

7. Press PAUSE again to put the printer online.

Setting Auto Report

This function allows you to disable or enable an automatic validator report printout after a batch job. The factory default is Disable.

You can determine the end of a batch job in two ways:

by using an Execute command, or

a timeout of more than 10 seconds.

To enable Auto Report:

.

1. Press .. to take the printer offline and place the printer in Menu mode.

2. If necessary, press and at the same time to unlock the key.

.

3. If necessary, press .. until “VALIDATOR” displays.

4. Press until “Auto Report” displays.

5. Press + or to scroll through the choices: Enable or Disable. The default is Disable.

6. When Enable displays, press to activate Auto Report.

7. Press and at the same time to lock the key, then press PAUSE to take the printer offline.

8. Press PAUSE again to put the printer online.

44

Page 44
Image 44
Printronix T5000e Series user manual Requesting a Validator Report, Setting Auto Report, Configuring The Validator