Chapter 1 Installation

Install The Ferrite

IMPORTANT If your printer has a factory installed validator, then the cable, ferrite, wire saddle, and grommet have already been installed. Go to “Install The Brackets” on page 23.

1.Loosen the two captive screws securing the top of the frame side cover. (Figure 2.)

2.Tilt the frame side cover back from the top and lift it until the tabs along the lower edge disengage from the slots in the printer frame.

Captive Screw (2)

Frame Side Cover

Figure 2. Removing the Frame Side Cover

16

Page 16
Image 16
Printronix T5000e Series user manual Install The Ferrite, Installation