Shifting The Scanning Beam
CALIBRATION Light
RESET Button
Calibration Bar Code Card
Deck Lock 
Lever
Figure 17. Calibrating the Validator
7.The scanning beam should turn off for a few seconds then back on, and the CALIBRATION light should turn off. This indicates a successful calibration.
NOTE: If the scanning beam does not turn back on and/or the calibration light is still on or flashing, the calibration has failed. In this case, refer to Table 2 on page 34 to repeat the calibration procedure or to reset the validator settings back to factory default.
8.Once you have a successful calibration, remove the calibration bar code card.
9.Close the pivoting deck and rotate the deck lock lever fully counterclockwise.
10.Close the media cover.
35
