Chapter 2 Basic Validator Setup
•RESET: This button is used in the calibration procedure and possible troubleshooting situations. Except in these specific circumstances, the RESET button should not be used.
Table 3. RESET Button Settings
Time RESET Button Is Depressed | Result |
|
|
|
|
Less than 2 seconds | Turns on scanning beam |
|
|
More than 4 but less than 6 seconds | Validator goes into calibration mode |
|
|
More than 6 seconds | Resets validator to factory calibration and |
| turns off scanning beam |
|
|
CAUTION Do not lift the printer by the validator unit or by the lower bracket.
CAUTION The validator contains sensitive electronic equipment. Do not jar or drop the unit.
40
