Chapter 1 Adjust The Scanning Beam

Adjust The Scanning Beam

NOTE: Make sure the printer is on and the scanning beam is on. If the beam is off, press the RESET button for less than 2 seconds to turn on the beam.

When the validator is first installed, the scanning beam may need to be aligned with the two notches on the sides of the tear bar, as shown in Detail A of Figure 12. When the scanning beam is properly aligned it will line up with the two notches.

A

Scanning Beam

Notch in Tear Bar

A

Figure 12. Aligning the Scanning Beam

28

Page 28
Image 28
Printronix T5000e Series user manual Adjust The Scanning Beam