Chapter 1 Adjust The Scanning Beam
Summary Of Scanning Beam Adjustment
To Move Beam | To Move Beam | To Rotate Beam | To Rotate Beam |
Down | Up | Clockwise | Counterclockwise |
|
|
|
|
|
|
|
|
Tighten top left | Tighten both bottom | Loosen bottom | Loosen bottom left |
screw | screws | right screw | screw |
or | or | or | or |
Loosen both | Loosen top left screw | Tighten bottom | Tighten bottom |
bottom screws |
| left screw | right screw |
|
|
|
|
NOTE: If the printer does not have a tear bar with notches at the ends, adjust the scanning beam so that the center of the beam is approximately 0.06 inches (1.52 mm) from the lower edge as shown in Figure 16.
0.06inches (1.52 mm)
Figure 16. Adjusting the Center of the Scanning Beam
32
