Attach The Power/Data Cable To The Validator
Attach The Power/Data Cable To The Validator
Power/Data Cable (Long Connector) 
Upper Bracket
Screw (3)
Cable
Channel
Bracket Tab
Grommet
Bracket Mounting Screw (4) 
Figure 11. Attaching the Power/Data Cable
1.Loosen the three upper bracket screws and route the power/data cable through the cable channel in the upper bracket, as shown in Figure 11.
2.Plug the long connector end of the power/data cable into the validator.
3.Route the power/data cable behind the bracket tab, as shown in Figure 11.
NOTE: If necessary, loosen the bracket mounting screws enough to slip the power/data cable behind the bracket tab, then retighten the bracket mounting screws.
4.Pull the cable to minimize the slack behind the lower bracket. Push any excess slack through the grommet.
5.Tighten the three upper bracket screws.
25
